The 1-port serial WAN interface card (WIC-1T) provides serial connections to remote sites or legacy serial network devices such as Synchronous Data Link Control (SDLC) concentrators, alarm systems, and packet over SONET (POS) devices.

Description:

Cisco WIC-1T 1-Port Serial WAN Interface Card

Product Details:

• One serial port.
• Uses the Cisco 60-pin "5-in-1" connector. This connector is DB-60 on one end and can be V.35, RS-232, RS-449, X.21 or EIE-530 on the other end depending on your needs
• Uses the same cabling as Cisco 2500 and Cisco 7000 serial ports.
• Does not support hot swap, however no hardware damage will occur if it is swapped while the power is on.
• Each serial card has one LED, labeled CONN for each port, which lights when the serial port is connected. When the port is in data terminal equipment (DTE) mode, the CONN LED indicates that Data Set Ready (DSR), Data Carrier Detect (DCD), and Clear To Send (CTS) have been detected. When the port is in data communications equipment (DCE) mode, it indicates that Data Terminal Ready (DTR) and Request To Send (RTS) have been detected.

Questions?

Contact our product team at email [email protected]

Guarantee:
All UNIXSeller hardware is fully tested, guaranteed and backed by a UNIXSeller warranty. This product comes with a 30 days Warranty from UNIXSeller and the product condition is Refurbished. UNIXSeller will support you, before, during and after the sale.

Product Expertise:
We know how important it is that you get the product that you need... whether to meet an install window or to show your boss or peers that you can get the job done right.
Don't hesitate to contact us with any questions regarding compatibility, condition or the best product available for your requirement. Our website represents only a fraction of our full inventory, but you can reach out with your complete requirements or lists of equipment for sale. [email protected]